Yamaha Oxygen Sensor Cleaning

[offshore]

Originally Posted by gary240

The sensor and tube were good to go, very little carbon, mostly around the threads of the sensor. The housing was the worst, but still wasn't that bad. I'm still going make it part of my yearly maintenance. I had to refer to the torque values you listed since my CD was cooperating.

Were yours bad?
Gary

Gary,
I had one that was worse than the other. One was relitively clean but the other had some deposits around the sniffer tube. The tube itself was fine. Mark

[wiernickir]

Mark, you mentioned the torque value of 35 lbs, is that inch lbs or foot lbs. of torque??

[offshore]

Originally Posted by wiernickir

Mark, you mentioned the torque value of 35 lbs, is that inch lbs or foot lbs. of torque??

It is FT/LBS....Mark